Article by: Gerry at PhoenixMotorsport Article applies to: all M7x V12 engines (750 and 850 BMW models). OK then, the next few “How To’s” are going to be in all sorts of different order but rather than do a “How to rebuild an E31” post, I am going to section […]

Article by: Gerry at PhoenixMotorsport Article applies to: all SOHC V12 BMW models. Ok, so continuing on from my last post on camshaft timing, I am elaborating on the delights of a BJ, (Banjo Job), that is so necessary on the V12. When I stripped down the top end of […]

Article by: Gerry at PhoenixMotorsport Article applies to: all e31, e32, and e38 BMW models with the M7x engine. Unfortunately, I need to apologize before I do this post because I did not keep stopping during the procedure to take photos. There is so many nuts and bolts to attend […]

Article by: 8Tech Article applies to: all models with the M70 V12 engine. Ok, so the next chapter in my eagerly awaited, is how to install an engine oil cooler on the V12. I have a slight advantage as with a CSi I already have one but with the mods […]

Article by: Michael Oswald Article applies to: all BMW models with the low impedance Bosch injectors. Problem: After installing a Perfect Power SMT-6 piggyback computer, I wanted to install new / used Bosch 24# blue top injectors. The SMT-6 has already been set up for these injectors. So, I went […]

Article by: Simon Worby Article applies to: E31, E32, E34, E36, and E38 models with aluminum blocks most notably the following: 320i, 323i, 328i, 520i, 523i, 528i, 530i, 540i, 728i, 730i, 740i(l), 840i What is the “Nikasil issue”? The “Nikasil issue” is a serious problem that affects all BMW motor […]