Article by: 8Tech Article applies to: all models with the M70 V12 engine. Ok, so the next chapter in my eagerly awaited, is how to install an engine oil cooler on the V12. I have a slight advantage as with a CSi I already have one but with the mods […]

Article by: Sean Article applies to: All BMW models with the M70 V12 engine. Problem: When replacing my water pump (all belts removed) I felt some shaft play on my alternator. Although the voltaqe regulator with brushes were recently replaced, I decided to replace the alternator when I could lay […]

Article by: Paul Axford Applies to: All models with the M30 big six engine (this article was written with a 730i). Note: some variations exist with early renditions installed in e9 and e12 models. The photo below indicates where some of these sensors are located. a) Cleaning the high-tension ignition […]

Article by: Paul Axford Applies to: All models with the M30 big six engine (this article was written with a 730i). Note: some variations exist with early renditions installed in e9 and e12 models. The photo below indicates where some of these sensors are located. a) Cleaning the high-tension ignition […]

Article by: Paul Axford Applies to: All models with the M30 big six engine (this article was written with a 730i). Note: some variations exist with early renditions installed in e9 and e12 models. The photo below indicates where some of these sensors are located. a) Cleaning the high-tension ignition […]

Article by: Paul Axford Applies to: All models with the M30 big six engine (this article was written with a 730i). Note: some variations exist with early renditions installed in e9 and e12 models. The photo below indicates where some of these sensors are located. a) Cleaning the high-tension ignition […]