The Ultimate Site for the Ultimate Driving Machine
Article by: Dudesky_E36 Applies to: All BMW models with small variations. Spark plugs should be replaced every 10,000mi or once a year. It’s a fairly simple process and takes less than a half hour to do. It is however important to take your time and pay attention to detail because […]
Article by: RobertRO Models: All BMW models with the M30 engine (or similar SOHC 4 cylinder engines). I needed a tool to easily remove the M30 cylinder head camshafts. Since I don’t have the BMW special tool, I had to go for a DIY approach. I used only materials that […]
Re-posted By: Green Lagoon Article applies to: applies to all BMW M30 engine blocks. Disclaimer: This valuable information is getting lost on the internet as time goes on. I am not the original author of this content. It was posted in various threads on m5board.com and e34m5.de. I am just […]
Article by: Paul Axford Applies to: all BMW models with the M30 engine (this article was written with a 730i). This initially looks like a formidable job but once you get the splash guard off the lower-front engine area it’s really very simple. Not so simple is getting the correct […]
Article by: Paul Axford Applies to: all models with the M30 big six engine (this article was written with a 730i). A vibration felt through the steering while starting the car was my cue that the engine mounts had failed. The replacement procedure involves raising the engine about 5 cm […]
Article by: Paul Axford Applies to: All models with the M30 big six engine (this article was written with a 730i). Note: some variations exist with early renditions installed in e9 and e12 models. The photo below indicates where some of these sensors are located. a) Cleaning the high-tension ignition […]